how would one go about using gsl-se housings with 2nd gen irons?
#1
Rotary Enthusiast
Thread Starter
Join Date: Feb 2008
Location: tennessee
Posts: 900
Likes: 0
Received 0 Likes
on
0 Posts
how would one go about using gsl-se housings with 2nd gen irons?
i want to know because i want to use some gsl-se hosuings that are pp ported in my 2nd gen
#3
Rotary Enthusiast
Join Date: Aug 2006
Location: Melbourne FL/San Antonio TX/Okinawa Japan
Posts: 1,216
Likes: 0
Received 10 Likes
on
10 Posts
Use some "DEVCON" sealent on the FC plates and have them surfaced flat. I never tried it but did talke to someone who did with good results. It was a "drag car" though.
Also seen FC rotor housing used with SA plates. They used Indian head gasket sealer, again for drag racing only.
chuck
Also seen FC rotor housing used with SA plates. They used Indian head gasket sealer, again for drag racing only.
chuck
Thread
Thread Starter
Forum
Replies
Last Post