how tight do i....
#1
Banned. I got OWNED!!!
Thread Starter
Join Date: Dec 2002
Location: wishing i was back in FL
Posts: 4,192
Likes: 0
Received 0 Likes
on
0 Posts
how tight do i....
tighten the 4 main bolts holding the carb down???? just snug them up or ballz out tighten them till i cant go any more....
#2
Nikki-Modder Rex-Rodder
Join Date: Feb 2001
Location: Trying to convince some clown not to put a Holley 600 on his 12a.
Posts: 2,890
Likes: 0
Received 14 Likes
on
6 Posts
Snug 'em!
Don't need to bear down too hard, but they should'nt be loose, either.
Check in a few days, and then again in a few days after that, as the gaskets compress.
Don't need to bear down too hard, but they should'nt be loose, either.
Check in a few days, and then again in a few days after that, as the gaskets compress.
#3
Banned. I got OWNED!!!
Thread Starter
Join Date: Dec 2002
Location: wishing i was back in FL
Posts: 4,192
Likes: 0
Received 0 Likes
on
0 Posts
well mr.sterling i think it matters not anymore for putting those gaskets on did nothing for that vaccum leak. MAKES NO SENSE! should i just try to get a new baseplate?
Thread
Thread Starter
Forum
Replies
Last Post
jjwalker
2nd Generation Specific (1986-1992)
7
09-23-15 09:25 AM
rx8volks
Canadian Forum
0
09-16-15 09:07 PM
msilvia
3rd Generation Specific (1993-2002)
15
09-11-15 12:13 PM