Does it exist a scoop that can be glued or screwed on the stock FB hood to create an intake that works. I know rotorhead.ca sells one, but i think it must be molded in the stock hood, i don't wanna mold it and repaint the hole thing.

Max

 

Screw in or glued? That'd look like crap! Plus the areas where the screws are will rust, slowly eating up your hood... A friend of mine used some glue-on scoop for his lightning (if I remember correctly)--I don't think he liked it very much (don't know why).

FS

 

I'm going to try and use a WRX hood scoop. Big enough to be center mounted and has a duct for cooling the turbo area. I got one off ebay for $72 with the mount assembly, though I don't know if I'll use it all.

Looks like I'll have to fab up some kind of a baffle to maintain flow to the TMIC. Scoop is same inlet cross section vertically but several inches wider.



I think it will mount up OK, but have to get the engine in first. Prolly several months away at this point.

 

I think i'll buy the TII hood scoop from rotorhead.ca and i'll mold it to my stock hood. I got a quotation of 350$ CDN for the molding and paint.

 

why dont you buy a fiberglass hood that allready has a scoop molded as part of the hood? 350 cdn plus the cost of the scoop? did the cdn drop agin to the usd? fiberglass hood with scoop aprox 175usd do a search there are a few guys here doing these hoods.

 

the hood scoop is 75$ USD. 350$ CDN is around 240$ USD.

 

v i racing in rosemead cali sells hood scoops. A replica of the TII hood scoop sells for appx $75. im heading up there this weekend for my RX-3.