Help Big trouble?
#1
Junior Member
Thread Starter
Join Date: Oct 2005
Location: New York
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
Help Big trouble?
When my 82 12a gets up to temp steam strarts coming out of my motor on the exhaust side? I live in the Northeast and had the anti-freeze set for about 10 below zero, it's not the thermostat housing new gasket and thermostat I put a new radiator cap on also , I can't see where it coming from.
I had performance issues slow RPM's and poor perfomance overall, so I swapped the fuel filter and fuel pump, plugs wires dizzy and it still didn't help? I worked on it Sunday when I noticed the steam coming out from under my hood, When I changed the thermostat some coolant leaked down the block but I it ran it for awhile and it didn't get any better. HELP
I had performance issues slow RPM's and poor perfomance overall, so I swapped the fuel filter and fuel pump, plugs wires dizzy and it still didn't help? I worked on it Sunday when I noticed the steam coming out from under my hood, When I changed the thermostat some coolant leaked down the block but I it ran it for awhile and it didn't get any better. HELP
Last edited by ThomasR; 03-27-06 at 05:47 PM.
#2
Lives on the Forum
There are two o rings between the intake and the block. These become deformed and brittle with age, and can start to leak. That might be your issue...
#3
Junior Member
Thread Starter
Join Date: Oct 2005
Location: New York
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
Thanks I have the parts ordered and I'm hoping that this is it, I really like my Rex and I'm new to this, rebuliding my 12a was not in my plans right, I may have pulled the trigger a little quick and didn't do my search like I was suppose to, so thanks again for you reply
Thread
Thread Starter
Forum
Replies
Last Post
FC3S Timmy
2nd Generation Specific (1986-1992)
16
10-03-15 01:08 AM
FC3S Timmy
2nd Generation Specific (1986-1992)
8
10-02-15 08:08 AM