ok here the deal i have no heater core.. so do i just pug off the ports or look the hoses.. if i pug then.. can i just tap the holes and uses a pipe plug and for the hoses that go thought the trottle body the coolant on a 13b.. fi do the can i do the same.. im getting the block off plates.. im just trying to clean up the engin bay a bit here... also i have been serching and so some unknown reason im looking for a wright up on the rats nest removel on the 88 13b fi any one have a link..

 

just cap the heater hose port at the radiator and at the other side of the motor

 

cool sounds good but now on to the rats nest

 

If you do emissions, don't remove the rats nest on a 13B. Ask the individuals in the 2nd Gen sectino about removing the rats nest if you still want to, since you said your ending is an '88.

 

ya i have been looking and looking... but nothin i have fond all kinds of wight ups for the first gens

 

ask people in the second gen section about the removal. They would likely know a bit better. Alot of guys in the first gen section are running the 12A motor, which there is a write up for.