GSL Third Member into a GSL-SE

Reply Subscribe

Thread Tools

Search this Thread

Sep 25, 2008 | 09:09 PM

borinquen7

Thread Starter

Senior Member

iTrader: (1)

Joined: Apr 2005

Posts: 266

Likes: 0

From: Marlborough,Ma

GSL Third Member into a GSL-SE

Hello everyone
I think I found a third member locally, but the problem is that the third member is from an 85 gsl, are the to able to be switched... I have a 85 gsl-se Thanks ahead, and yes I searched but no specific answer....

Sep 25, 2008 | 09:32 PM

13BT_RX3

The General RE

Joined: Apr 2003

Posts: 924

Likes: 13

From: San Diego, CA

Yes it should fit.
84 and 85 gls and gsl-se have the same spline count.

Sep 26, 2008 | 01:05 AM

DasBoost

Yeah..It's broken again!

Joined: Aug 2008

Posts: 38

Likes: 0

From: New York City

Fits perfect with no problems in my SE. Broke 2 of them already.

Sep 26, 2008 | 10:18 AM

racermike

aheadau

Joined: Dec 2002

Posts: 411

Likes: 0

From: St. Louis, Mo.

Won't the wheel bolt pattern be different for front and back then?

Sep 26, 2008 | 10:42 AM

Rotaryhaven

Total Rotary Domination!

iTrader: (17)

Joined: Apr 2002

Posts: 1,916

Likes: 1

From: Hampton, Virginia

you are only using the pumpkins. bolts right in.

lift car up
take tires off
take driveshaft off pumpkin
drain gear oil.
take calipers off and brake cables, rotors
loosen backing plates
take an axle slide hammer, remove axles
loosen pumkin bolts, take old one out and install new one
Installation is in reverse order

Last edited by Rotaryhaven; Sep 26, 2008 at 10:44 AM.