.Does the Diff end of the TII driveshaft match the GSL-SE Diff?

 

I haven't seen it myself, but I've heard that Tii will not fit any FB differential flange, and an FB driveshaft will have a small spline pattern which won't fit the TII trans. An FC automatic had a large trans spline pattern, with a smaller differential connection, but the driveshaft length is too long or short to use in an FB. I've done lots of digging to find this info, but I cannot validate it.

 

You can buy the TII front flange and the GSL-SE rear flange from MazdaTrix and then have a driveshaft shop make one.

Driveshafts

 

Thaks guys. This is actually a pretty custom setup. Its a TII tranny on a Toyota 4age using a GSL-SE rear end all going in a KP61. Having some fun with a different setup so I can buy the TII driveshaft and just have the GSL-SE flange put on cause the driveshaft has to be cut and shortened anyhow.

 

The best deal for me was to call Mazdatrix and ask them to make me an FB driveshaft with a TII front yoke. This was almost half as much as when I had a local driveshaft shop make me a custom one.