bajerx7

.Does the Diff end of the TII driveshaft match the GSL-SE Diff?

laundryhamperman

iTrader: (3)

I haven't seen it myself, but I've heard that Tii will not fit any FB differential flange, and an FB driveshaft will have a small spline pattern which won't fit the TII trans. An FC automatic had a large trans spline pattern, with a smaller differential connection, but the driveshaft length is too long or short to use in an FB. I've done lots of digging to find this info, but I cannot validate it.

KansasCityREPU

iTrader: (9)

You can buy the TII front flange and the GSL-SE rear flange from MazdaTrix and then have a driveshaft shop make one.

Driveshafts

bajerx7

Thaks guys. This is actually a pretty custom setup. Its a TII tranny on a Toyota 4age using a GSL-SE rear end all going in a KP61. Having some fun with a different setup so I can buy the TII driveshaft and just have the GSL-SE flange put on cause the driveshaft has to be cut and shortened anyhow.

DreamInRotary

iTrader: (49)

The best deal for me was to call Mazdatrix and ask them to make me an FB driveshaft with a TII front yoke. This was almost half as much as when I had a local driveshaft shop make me a custom one.