Full GSL-SE motor, manifold, flywheel, clutch, ect. I want $500, clutch seems to still be good didn't slip a bit before i took it out, but i'm no expert, flywheel and pressure plate does have heat spots though, but nothing too severe. it includes everything but two corner seals. Seems whoever rebuilt it before me was lazy and didn't put them in. The ring is there, but the rubber isn't in the center. Some assembly required. Can either be picked up or shipped, but i'd hate to see the shipping expense.

Stock exhaust manifold has a broken stud and would need to be drilled out, i can include a header in nearly mint condition for an extra $180 (includes a thick aftermarket gaster and post header gasket again in near mint condition) .

 

if you know the corner seals arn't there that means you have removed cover off the rear or front? so that means it has to be rebuilt right? seems pricie for a motor that requires a rebuild. thats my thoughts on it. sorry man don't mean to shoot your flame out or anything.

Jerad

 

Don't wanna soudn liek an *** but whole cars (rx7's) you can come by for a few hundred with a blown motor

 

I realize this, but it is a gsl-se motor, i need money to buy a car and i'm jobless, i have to drive my mother's spare car around. The motor was rebuilt not too long ago and the apex seals, side seals, ect can be reused. I was just hoping someone would be interested and could negotiate a price. All it does need is the seals on the sideplates and 2 corner seals. That's why i will include everything for $500, i can also include everything needed to put the 13b into a non-se, or almost everything. I can throw in the transmission too, but the tranny definately would need rebuilt. If anyone is seriously interested we can negotiate.

 

That's cool, well I wish you the best of luck and if i hear of anybody needing a 13b 6 port ill send them your way

 

Hopefully they could come pick it up, shiping would be outrageous.