gsl-se fuel problem
gsl-se fuel problem
What would make the car idle and run, but not run on high RPM's?! For example... I can drive at 3,000 RPM's, and as soon as I get any higher, it boggs down until I let off the gas pedal and then lightly reapply gas. New fuel filter, but it was installed backwards. Do i need to change out the filter, or could it be something else?
Alright this may sound fucked but I had the same sort of problem! It wouldn't rev past 3-4grand. and had no power, atleast not enought to even peel out.
Here's what I did, you see those emission harness clips on the drivers side of the re-egi manifold. There should be two, one green and the other orange. Now unplug one of them while engine running. then pull on the throttle cable and see if the problem has gone away, if not try the other one and plug the first one back in. Then if still nothing unplug both.
You engine should idle smoothly when you remove one of the clips. then you know that was the right one to unplug.
Unfortunately I don't know how to fix it, what I did was bypass that emissions trigger by putting a jumper in the clip from one wire to the other and taped it up. My car has run perfect since!
Here's what I did, you see those emission harness clips on the drivers side of the re-egi manifold. There should be two, one green and the other orange. Now unplug one of them while engine running. then pull on the throttle cable and see if the problem has gone away, if not try the other one and plug the first one back in. Then if still nothing unplug both.
You engine should idle smoothly when you remove one of the clips. then you know that was the right one to unplug.
Unfortunately I don't know how to fix it, what I did was bypass that emissions trigger by putting a jumper in the clip from one wire to the other and taped it up. My car has run perfect since!
Bypassing the emissions valve just fools the system into thinking it's open. Problem starts when those emissions (rats nest) starts to malfunction. Its a series of soleinoeds. That open and close and vent vacuum inorder to open and close different passages.
thanks for the replies. very sweet, i been playing with this **** for the last couple of days. the NEW filter is in correct and still the same problem. i will try the suggestion tomorrow, thanks.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
alphawolff
1st Generation Specific (1979-1985)
17
Nov 17, 2015 05:57 PM




