Gearbox Question
Thread Starter
Adolf Hitler Verfechter
Joined: Sep 2002
Posts: 969
Likes: 0
From: Northern South Africa
Gearbox Question
So i stuffed the selector fork on my gearbox.
Does anyone know if the internals of the B2200 Mazda trucks are the same ?Also would i be able to fit a B2200 one,and will it be stronger?
I have the bad habbit of bending selector forks.
All input will be appreciated !
K
Does anyone know if the internals of the B2200 Mazda trucks are the same ?Also would i be able to fit a B2200 one,and will it be stronger?
I have the bad habbit of bending selector forks.
All input will be appreciated !
K
Old [Sch|F]ool
Joined: May 2001
Posts: 12,856
Likes: 568
From: Cleveland, Ohio, USA
Should be the same internally. Just swap the front and rear housings off of your RX-7 trans onto the B2200 trans.
Make sure that the shaft lengths are the same, first. Some trans had a different length input shaft, so be careful.
It won't be any stronger. Personally due to the gear ratio differences I'd just use the B2200 trans for the parts needed to repair the RX-7 trans.
Make sure that the shaft lengths are the same, first. Some trans had a different length input shaft, so be careful.
It won't be any stronger. Personally due to the gear ratio differences I'd just use the B2200 trans for the parts needed to repair the RX-7 trans.
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic S5 Turbo PNP Unit questions
_Tones_
Adaptronic Engine Mgmt - AUS
10
May 25, 2021 05:37 AM
Nosferatu
2nd Generation Specific (1986-1992)
7
Sep 5, 2015 02:13 PM