jutny

i replaced my "holy" gas tank in my 80 with the perfect tank from my 79 racecar project... however, the problem is now, that the sending unit is reading very low on the gauge, when its full, it reads between 3/4 to half on the meter. The sender from the 80 tank seemed to work well.

is there any way i can replace the sender, or calibrate the gauge or something like that? because now that i'm getting MUCH better mileage (due to not having holes in the gas tank)... i'd like to actually know how much fuel i have.

Bluezone

iTrader: (1)

bmp

MosesX605

Check out this thread:

https://www.rx7club.com/forum/showth...ght=gas+sender

It refers to a GSL-SE, but I think that it still applies. As for removing the sender unit, I do believe that you have to drop the tank.

Good Luck

Wankelguy

I'd just replace the sending unit with the good one from your '80. It'll fit just fine.

jutny

the screws and everything on the one from the 80 are so ******* rusted and corroded that i'm not even sure i could get it off... are new ones available?

*runs off to check mazdatrix*