Gas pedal adjustment
FYI - This is for a race setup car (SRX7).
So, the Haynes & FSM says the gas pedal should be 1.8" below the brake. My quick measurement shows mine is farther back than that, probably 2.2-2.5" If I bring this up a little by adjusting the pedal position adjustment nut, will I have to then adjust the free play nut in the throttle line and/or the stopper bolt for full opening? Anyone mess with this? Can I adjust the pedal position adjustment nut without affecting throttle response negatively?
My purpose is to better heel toe on the track. Right now it's quite a reach (and a PITA).
So, the Haynes & FSM says the gas pedal should be 1.8" below the brake. My quick measurement shows mine is farther back than that, probably 2.2-2.5" If I bring this up a little by adjusting the pedal position adjustment nut, will I have to then adjust the free play nut in the throttle line and/or the stopper bolt for full opening? Anyone mess with this? Can I adjust the pedal position adjustment nut without affecting throttle response negatively?
My purpose is to better heel toe on the track. Right now it's quite a reach (and a PITA).
Joined: Mar 2001
Posts: 31,835
Likes: 3,233
From: https://www2.mazda.com/en/100th/
i think you might have to adjust the carb end, but its very easy to do that. since its a race car you may want to verify that the carb is actually fully open, when you floor it.
and actually since its a race car, you may want to try a couple of different pedal heights and go with the most comfortable
and actually since its a race car, you may want to try a couple of different pedal heights and go with the most comfortable
i think you might have to adjust the carb end, but its very easy to do that. since its a race car you may want to verify that the carb is actually fully open, when you floor it.
and actually since its a race car, you may want to try a couple of different pedal heights and go with the most comfortable
and actually since its a race car, you may want to try a couple of different pedal heights and go with the most comfortable
Thread
Thread Starter
Forum
Replies
Last Post
The1Sun
New Member RX-7 Technical
5
Sep 15, 2015 04:45 PM
Adaptronic 1280s Hot Start 3 Rotor 20b RX7
Monsterbox
Adaptronic Engine Mgmt - AUS
5
Sep 11, 2015 03:29 PM
The1Sun
1st Generation Specific (1979-1985)
0
Sep 7, 2015 10:21 PM







