Fuse box and ecu problem
#1
Junior Member
Thread Starter
Join Date: Dec 2015
Location: Florida
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
Fuse box and ecu problem
The hazard lights don't work as I found out last night. The Blinkers and head lights and other electrical works. The light on the rearview mirrors doesn't work as well as the antenne of the Radio I don't know why it never pulls up. I have a huge mess of wires and I can't figure out how it's supposed to be connected
The one hanging is the alarm but I don't know the rest what is for what or where it should go. I want to know how I can make it work properly so that I know the gas level in the tank
The one hanging is the alarm but I don't know the rest what is for what or where it should go. I want to know how I can make it work properly so that I know the gas level in the tank
#6
Junior Member
Thread Starter
Join Date: Dec 2015
Location: Florida
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
Rx7 slightly fixed
The lights Blinkers etc. Work after I changed the fuses. I have extra and it was open on Some slots. The car starting works fine and do not need to press gas pedal or pump it. It does need to choke a few times.The car also had smell of gasoline, after I took it on a Spin it was fine. When I try to accelerate the car it wants to die on me as the rpm goes low. If I can get it to accelerate it will go only up to 2500 or 3000 rpm then it Starts to lose rpm and I have to let go of the Gas pedal. That's when the rpm goes from under 500 to about 1500 and back to 1,000's idle rpm. It revves fine in neutral and parking gear. I also have the light turned off that says the fuel is low on the tank, but the gauge says E so the problem wasn't fixed.
Last edited by Alessandro Gentili; 12-26-15 at 06:35 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Alessandro Gentili
1st Generation Specific (1979-1985)
14
12-08-15 12:37 PM