Specs: 1985 Mazda RX-7 w/ 1.3L

The problem I am having is the car doesn't want to run, I can start it by pouring a small amount of fuel into intake but then it stalls out. I have replaced the inline fuel pump and the fuel filter...what else should I be checking? and FYI it has a 1/4 tank of gas.

 

1.7 L...well what did you swap in there...there are no rotaries that are 1.7 L..you have the 12a's 1.1 L and the 13b's 1.3

 

Need to rebuild the carb. Has it been sitting up for awhile?

 

if its the GSLSE its probably FI so he probably has to do more than he thinks he does.

 

The reason I say carb, is because on a FI rotary you cant just pour gas down the intake like he stated he has tried.

 

WHERE DO YOU SEE 1.7

 

Last edited by Kdog : 03-21-08 at 12:06 AM. Reason: typo

 

If It's a SE model check your main fuel injection relay and make sure both circuits it controls are powering up with the ignition on. It could also be a problem with your circuit opening relay not working correctly or even the ECU. If it turns out your car is carb'd then swap a fuel injected engine into it. lol!

 

he had 1.7 up there..he edited it...

 

i forgot to mention that after i put the fuel pump on it ran, i drove it around the block then it jst cut off and wouldnt turn back on