Flywheel replaceable friction surfaces
01-13-04, 06:16 PM
#3
EX Pres of DFW Drunks
Originally posted by wackyracer
RB replacement friction plate runs appx $75. It says it will fit both 215 and 225....ITS A LIE. I bought one appx 5 years ago and it was for a 225. Same part #.
RB replacement friction plate runs appx $75. It says it will fit both 215 and 225....ITS A LIE. I bought one appx 5 years ago and it was for a 225. Same part #.
turns out the plate was for an 225mm flywheel and the flywheel was a 215mm.
I still have it ifyou wnat to buy it. (friction plate that is) I'll sell it for less than RB does, never used.... PM me.
01-15-04, 02:24 PM
#5
10mm. j/k. I can be made tho. I've visited 10,000 RPM in Palmdale CA several years ago. They looked at the flywheel and told me that they can make it. I didnt follow up since I found several old friction plates in my garage (Never throw things away) and my buddy was able to clean it up.
As long as there are no deep scratches, not warped and no exposed screws, it can be re-used. Also, I used that flywheel along with carbon kevlar disk til I switched to stock flywheel and puck clutch.
As long as there are no deep scratches, not warped and no exposed screws, it can be re-used. Also, I used that flywheel along with carbon kevlar disk til I switched to stock flywheel and puck clutch.
Last edited by Siraniko; 01-15-04 at 02:27 PM.
Thread
Thread Starter
Forum
Replies
Last Post
rx8volks
Canadian Forum
0
09-01-15 11:02 PM
