Any one ever hook up a A/F Gauge to the RB Full StreetPort Exhaust System?
Got the Nordskoog Digi Gauge w/sender and need to know how's to & where in the system to Weld in the Bung.
Any info will help???
84GSL StreetPort w/RB Holley SP & RB Full SP Exhaust.

Oh where Oh where to Weld this Bung.
Thanks
sgieldon
steve

 

I was wondering the same thing. I always wanted to install a/f guage to help tune my carb but was unsure on where to weld the bung. I'm running a streetport exhaust as well.


Thanks, Ed

 

Bump!!!
Hopefully someone out there will come up with an answer to this ???
Since this set-up has 2 sections all the way back out the Muffler.
I was reading threw the Search Section on this ? and found only 1 answer which is to Hook Up 2 Gauges and run them thru each Pipe.
That's Nuts!!!

Someone out there has done this Mod Somewhere!!!
HELP US
Thanks
sgieldon
steve

 

just put it on either pipe about 8 inches out from the block. its' really pointless tho, that narrowband isnt going to tell you anything. just a light show.

 

Put it where the O2 sensor goes stock. If you dont know where that is on the RB Header, its right at the end near the flange.

 

yes. no need for a guage, unless its a wideband.

 

Well considering the RB StreetPort Exhaust SetUp has 2 Dedicated Tubes running from the block all the way back out the Muffler thats not going to work correctly i.e. Drill before the Flange.
If you have a RB Catalog, look on page 25 on the bottom and you'll see what I'm talking about.
Thanks
sgieldon
steve

 

it wont tell u a light show it helps alot just about 8 inches from the motor it has helped tune my car greatly