Ok, Got my 13B 4 port running good now, (just some minor ****). What wires from engine harness do i need to hook up? And where is each sensor located?


example: water temp, oil light, alternator.

I got a 80 rx-7.

Thanks, Gonzz

P.S. See everyone at Sevenstock 5, It's gonna be nice..

 

Ok, this is what I can remember from when I did my 12A...

1. Oil Pressure ("mushroom" looking sensor on the drivers side under the oil filter neck)
2. Low Oil Warning (Oil pan, drivers side)
3. Some other thing on the oil pan (Other connector on the oil pan next to the oil level sensor)
4. Coolant temp (below the filter neck, looks like a mini spark plug)
5. Coolant level (top of the radiator)
6. Some other thing on the radiator (Bottom drivers side corner of the radiator)

Well, when I started writting this post I thought I knew more...Oh well. Theres what I know.

~T.J.

 

You still got the old harness from the motor? Theres all the answers if you see where they attached on the motor and on the harness...

I know on mine alt was white/black
oil pressure was brown/wht (i think)
coolant temp was brown/yellow(i think)
oil level I forget?

Get the old harness and look where they went, and/or the Haynes manual.

 

at RMD: #3 in your post is the oil temp sensor its for the sub zero starting assist bullcrap
#6 i didnt know what it was for, id say its another pressure or temp switch??