E-Brake setup?????
#1
****ty Tune= Low #'s
Thread Starter
E-Brake setup?????
Since i did the rearend swap on my car i havent had any ebrake setup and i the reason being that the cables are too short,
i can hook one cable up from the drive side caliper up to the front cable but the passenger side cable is about 3 inches to short of reaching the connection..the cables came with the rearend setup and when i was looking at ordering new cables all together there was no difference in the front section of the cables but obviously a difference in the disc and drum setup...but on the disc cables is there a difference in the left and right cables as in length like i have the left and right cable swaped or somthing????????
i can hook one cable up from the drive side caliper up to the front cable but the passenger side cable is about 3 inches to short of reaching the connection..the cables came with the rearend setup and when i was looking at ordering new cables all together there was no difference in the front section of the cables but obviously a difference in the disc and drum setup...but on the disc cables is there a difference in the left and right cables as in length like i have the left and right cable swaped or somthing????????
#5
callin' tokyo
Join Date: Dec 2002
Location: Windsor, Ontario
Posts: 1,353
Likes: 0
Received 0 Likes
on
0 Posts
The GSL-SE are the same length (right to left) but the GSL are different lengths (right to left) with the driver's side beeing shorter so that you can hook it up without removing the heat shield.
Thread
Thread Starter
Forum
Replies
Last Post
eplusz
General Rotary Tech Support
15
10-07-15 04:04 PM
joel(PA)
Race Car Tech
0
10-01-15 10:25 AM