dyno help!!!!
#1
dyno help!!!!
ok here is the thing.....i am helping to dyno a bridge 12a with a holey on it.....it is a enertia wheel dyo....we cant get the car to go over 5000 and when we pull it starts to heat up really fast almost imediate temp rise...i dont remeber how to get the timing right on these...advanced is all the way to the right correct?
any links on this would help and dyo set up too
any links on this would help and dyo set up too
#3
ok yea sorry i was on my way out the door so my first post was short...ok here is the deal it is a carbed bridge 12a....we hooked it up to the wheel and did a pull ....almost immediately the temp climbed to 200 i thought it was timing so i checked the timing with a light..the markes are close but they jump around alot..sometimes they even dissapear? i wondered if it was the pair of MSD 6al we have on..........so what should i do about checking the timing marks and also does anyone know whta the crank angle of fire is we set it at 120 degrees but i am getting some wierd torque readings and HP readings.....so finally any links on set up and correcting faulty timing would be great
Thread
Thread Starter
Forum
Replies
Last Post
HalifaxFD
Canadian Forum
126
05-09-16 07:06 PM