Drive shaft question
05-22-21, 04:28 PM
#1
Admitted 'rexaholic'
Thread Starter
Drive shaft question
In doing an auto to manual conversion I
tried to install what I was told was a driveshaft for a manual.
It’s too long by a good inch and half.
I put it alongside the auto driveshaft I removed, they’re the exact same length.
Should a manual drive shaft be shorter?
Also will an FB driveshaft work on an SA?
tried to install what I was told was a driveshaft for a manual.
It’s too long by a good inch and half.
I put it alongside the auto driveshaft I removed, they’re the exact same length.
Should a manual drive shaft be shorter?
Also will an FB driveshaft work on an SA?
Last edited by mwpayne; 05-22-21 at 05:08 PM.
05-22-21, 07:03 PM
#3
1984/1985 FB Auto and Manual drive shafts lengths are 38.1 inches. (source: Section 8 of 1985 Factory Service Manual)
I could not find the 1979/1980 SA length but I don't believe the SA/FB S3 are the same. Can't speak for the SA/FB S2.
I could not find the 1979/1980 SA length but I don't believe the SA/FB S3 are the same. Can't speak for the SA/FB S2.
Last edited by KansasCityREPU; 05-22-21 at 07:11 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Kiflin
3rd Generation Specific (1993-2002)
3
03-02-05 01:32 PM
silverflash2
3rd Generation Specific (1993-2002)
3
03-14-03 10:01 PM