DLIDFIS question
09-13-04, 10:48 PM
#3
Full Member
Thread Starter
Join Date: Mar 2004
Location: manitoba,canada
Posts: 153
Likes: 0
Received 0 Likes
on
0 Posts
i know i dont have a ballast resistor but i was reading the haynes manual and it says that i have an ignitor box instead of a balast resistor.. no clue what it looks like or what it even done...i guess i should of asked what it is before this queastion haha but i guess its not that important if you dont even know what it is
haha that
haha that
09-13-04, 10:55 PM
#5
Full Member
Thread Starter
Join Date: Mar 2004
Location: manitoba,canada
Posts: 153
Likes: 0
Received 0 Likes
on
0 Posts
probably.. i was wondering why i couldnt find it, sometimes i just confuse the hell outta myself with this whole ignition stuff...its not that hard to figure out, i just come up with things and make it a whole lot more complicated then it should be:S
09-13-04, 11:55 PM
#6
Right near Malloy
iTrader: (28)
Join Date: Dec 1999
Location: Behind a workbench, repairing FC Electronics.
Posts: 7,841
Received 511 Likes
on
346 Posts
https://www.rx7club.com/1st-gen-archive-71/ignition-dlidfis-installed-small-write-up-some-questions-216618/
Check'er out... Should give you everything you need.
Check'er out... Should give you everything you need.
09-14-04, 12:05 AM
#7
Full Member
Thread Starter
Join Date: Mar 2004
Location: manitoba,canada
Posts: 153
Likes: 0
Received 0 Likes
on
0 Posts
ya, i have read that but it doesnt say anything about the supposid ignitor box... maybe i was just looking at the wrong part in the manual.. i will chek it out tomorow
Thread
Thread Starter
Forum
Replies
Last Post
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM