Did I get ripped off??
#1
Junior Member
Thread Starter
Join Date: Dec 2002
Location: Boise
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
Did I get ripped off??
Hey guys, I bought a used set of what i was told were Racing Beat sway bars, front and rear for 100.00. Later, as I was looking for parts online I noticed that most aftermarket bars are several mm larger, while the bars I bought look the same size as stock. I havent been out to my shop to measure them lately, but by eye they look the same. What I need from you guys is measurement in mm of racing beat sway bars, how big around are they? and how big are the stock ones? I will measure them all tommorow, but I thought maybe you guys had some input to help out. Thanks in advance!
- RJ
- RJ
#4
add to cart
Join Date: Jun 2002
Location: Saskatoon, SK & Montreal, PQ
Posts: 4,180
Likes: 0
Received 0 Likes
on
0 Posts
front racing beat bar is bright red and thick.
Rear bar is plated bare metal, noticeably thicker than stock but not as thick as the front, red one.
Rear bar is plated bare metal, noticeably thicker than stock but not as thick as the front, red one.
#6
Junior Member
Thread Starter
Join Date: Dec 2002
Location: Boise
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the info
thanks for the info guys, I think the front one is ok, but i am suspicious about the rear, tommorow I will measure and that will tell me for sure. thanks again!
- RJ
- RJ
Thread
Thread Starter
Forum
Replies
Last Post
LongDuck
1st Generation Specific (1979-1985)
12
10-07-15 08:12 PM
t-von
3rd Generation Specific (1993-2002)
9
09-10-15 01:56 PM