Dellorto DCOE 45mm carby??
#1
Full Member
Thread Starter
Join Date: Nov 2003
Location: Sydney, Australia
Posts: 98
Likes: 0
Received 0 Likes
on
0 Posts
Dellorto DCOE 45mm carby??
Hey guys looking for a bigger carb for my 12a (stockport + extractors), I don't plan on using it yet but i know someone who has one of these going for cheap...
Just wondering how well will they work with the 12a, will it hook upto a webber manifold? and if i get it rejetted etc how far would it go say if i start to port my engine.
Also what does DCOE/IDA ect ect mean?
thanks.
Just wondering how well will they work with the 12a, will it hook upto a webber manifold? and if i get it rejetted etc how far would it go say if i start to port my engine.
Also what does DCOE/IDA ect ect mean?
thanks.
#2
Full Member
Thread Starter
Join Date: Nov 2003
Location: Sydney, Australia
Posts: 98
Likes: 0
Received 0 Likes
on
0 Posts
ok so the difference between DCOE and IDA is how the are monted (down/side) so does this mean i just need to get the 2 piece intake manifold?
and does anyone know where i could get the uper half of the manifold , oh and once again does it use the same bolt patten as the weber?
and does anyone know where i could get the uper half of the manifold , oh and once again does it use the same bolt patten as the weber?
#4
Originally Posted by Shamrock.James
ok so the difference between DCOE and IDA is how the are monted (down/side) so does this mean i just need to get the 2 piece intake manifold?
and does anyone know where i could get the uper half of the manifold , oh and once again does it use the same bolt patten as the weber?
and does anyone know where i could get the uper half of the manifold , oh and once again does it use the same bolt patten as the weber?
#5
Full Member
Thread Starter
Join Date: Nov 2003
Location: Sydney, Australia
Posts: 98
Likes: 0
Received 0 Likes
on
0 Posts
ok figured i will need a whole new mani, the racing beat one needs both the top and the bottom, so anyone know where i can pickup one of the 1 piece wraparound manifolds?