Will a clutch master cylinder for an '85 F.I. model work for a '85 carb model? Thanks

 

Anyone?

 

They are different part numbers, i believe that the hard lines are different, rx7doctor

 

Could I just bend the line a little?

 

It might be the fitting size that is different. There might be a thread somewhere on this, go to advanced and do a search. rx7doctor

 

yea, they swap. at least mine did no problem. i took a gsl-se master and slave and put it on my 85 base.. works fine.

 

The 13b and 12a masters have different part#'s, did you just have to rebend the line? rx7doctor

 

Okay so the master AND slave have the same bolt dimensions for the gsl-se and the base model, right?
Last Q: If I get a 13b master do I also need a 13b slave for it to work?

 

Yes to question 1, on ? #2, no you dont have to use the se slave, the clutch hoses are all the same, it's the hard lines that are different either in configuration/size, or lenght, i have an se and 2 gsl's, 1 will look at them tommorow and see if ic ant give you a better answer.
rx7doctor