carter mounting questions
04-13-06, 06:11 PM
#27
Hunting Skylines
Join Date: Apr 2001
Location: Brisbane, Queensland, Australia.
Posts: 3,431
Likes: 0
Received 2 Likes
on
2 Posts
Originally Posted by peejay
It may not be immediately obvious, but you have to puch those plugs on *firmly*. The end of the connector actually fits over the plastic part of the pump's stud, requires a bit of force to snap it into place the first time.
04-13-06, 07:01 PM
#28
---
Thread Starter
Join Date: Sep 2005
Location: Minneapolis, MN
Posts: 569
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by peejay
It may not be immediately obvious, but you have to puch those plugs on *firmly*. The end of the connector actually fits over the plastic part of the pump's stud, requires a bit of force to snap it into place the first time.
04-13-06, 07:45 PM
#29
FWIW I mounted my mallory on the sheetmetal behind the bins. The plumbing section actually had some 1/2" thick rubber washers, dunno what they are originally designed for but they're great sound insulators. Though the Mallorys are known to be quiet (so I can't comment on noise levels) I can say that mounting it there seemed fine to me, just make sure you place it properly so that you clear your swaybar. When I first put mine on and lowered the car onto its wheels, the saybar started smacking into it. Damn near almost knocked it loose the first drive I took with it. I dropped it a half inch lower than I had mounted it and the problem was solved.
Jon
Jon
04-14-06, 02:03 PM
#30
Originally Posted by peejay
This pump is damned near silent, I don't know what you people are complaining about. (And yes I'm counting when the engine isn't running 
)
)
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM
CaptainKRM
2nd Generation Specific (1986-1992)
14
08-26-15 09:52 PM