1st Generation Specific (1979-1985) 1979-1985 Discussion including performance modifications and technical support sections

Carb rebuilt, refuses to idle below 1200rpm

Thread Tools
 
Search this Thread
 
Old 03-13-04, 05:58 PM
  #1  
Full Member

Thread Starter
 
Join Date: Mar 2004
Location: North Cakalaky
Posts: 51
Likes: 0
Received 0 Likes on 0 Posts
Carb rebuilt, refuses to idle below 1200rpm

Rebuilt carb, but engine refuses to idle below 1200rpm. Should timming be retarded to alow engine to idle? Timming was fine before rebuild, but car would not run above 50 mph. Car still will not run above 50mph. Therefore, could the timming been advanced since time of purchase?
modifications since problem began:
new fuel pump (aftermarket)
fuel filter
cleaned gas tank (no sediment)
new distributor cap, rotor, wires & plugs.
Old 03-13-04, 06:29 PM
  #2  
Senior Member

 
RXTbone's Avatar
 
Join Date: May 2003
Location: Kansas
Posts: 576
Received 2 Likes on 2 Posts
I'm not a carb guru - but have you checked the throttle linkage and made sure it's adjusted properly?
Old 03-13-04, 06:34 PM
  #3  
Full Member

Thread Starter
 
Join Date: Mar 2004
Location: North Cakalaky
Posts: 51
Likes: 0
Received 0 Likes on 0 Posts
I have not ajusted it since the rebuild, but there's play on both cables, so I know there not overtight.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
ZacMan
Build Threads
4
09-19-15 09:20 PM
ZaqAtaq
New Member RX-7 Technical
2
09-05-15 08:57 PM



Quick Reply: Carb rebuilt, refuses to idle below 1200rpm



All times are GMT -5. The time now is 07:52 PM.