Ok I'm rebuilding my nikki and all is good besides this little rod fell out and I have no clue where it goes. I searched high and low and can't find anything. Schematics show where the other two weights and ***** go but can not find where this one goes!!

 

also the guide I have for stripping the carb says to drill out the axial jet to 5/64 and the the nozzles on the squirter to .050. Conpared to what in there it seems pretty massive! I didn't do it. But is that right?
Here's what in working with

 

that's a check weight. . if you look at your diagram, it should be piece 71.

 

Got number 71 and 74 installed. That's the short fat one one the small skinny one. This ones fat and longer. The other two get a ball with them this ones just a weight. The schematic I showed here is what I'm using for the "strip". The rebuild schematic that came the the rebuild kit only goes up to 70 and it's not there!

 

I found one thread in this and the guy said it goes in the richer circuit?

 

Ok never mind I finally found a thread about it. It how under plug number 93. I don't understand y it wouldn't be on any schematics? Pretty stupid.