Carb Abd Manifold Swap
Thread Starter
Joined: Nov 2001
Posts: 951
Likes: 3
From: Las Cruces, NM
Carb Abd Manifold Swap
Hey guys. I'm about to swap in a RB intake manifold and an edelbrock 400 in place of my nikki stuff. I was wondering from those of you who have already swapped your carbs and manifolds, anything I should know? Any tricks I need to know to make it go smoothly? How much of the smog control stuff can I take off? The original nikki has millions of little tubes going everywhere. Will I need any of this on the new carb?
Bimmer *****
Joined: Jun 2002
Posts: 2,199
Likes: 1
From: Plano, TX
u won't want to run any of that crap with the new carb.... if u look at my motor all i got on it is carb/intake and exhaust manifold, and of course ignition... u can run very minimalistically...
don't mind the dirt
don't mind the dirt
Originally Posted by Elysian
u won't want to run any of that crap with the new carb.... if u look at my motor all i got on it is carb/intake and exhaust manifold, and of course ignition... u can run very minimalistically...
don't mind the dirt
don't mind the dirt
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
RotaryBobby
1st Generation Specific (1979-1985)
14
Sep 14, 2015 01:20 PM