78Savanna

I have a 12a and need new ignition wires. Where is a good place to get good Ignition Wires? What Brand? Do you think it is better to buy or to make the wires? What do you guys use?

FirebirdSlayer666

iTrader: (3)

Just get some pre-made wires. IT's not really worth the hassle to fight with making your own. You can either pick up a set from your local auto parts store or you can get sets from rockauto.com or mazdatrix.com etc.

Kentetsu

Since I am using a 2nd gen coil, mounted on the strut tower, the stock plug wires were much much longer than I needed. I built my own using a kit from Autozone. I believe it is made by Accel. Worked out great.



.

chris_g

iTrader: (29)

I bought one from Advanced Auto Parts I think.

One of the wires JUST fit. Too tight for my liking actually.

Now I have the 2nd gen coil and I have to make more wires this winter.

mazdaverx713b

iTrader: (91)

i ONLY use NGK wires. i get them from napa for around $20 and they are custom fit for the 7.

Stock #: 8172

Part #: RC-ZE97A

Sgt Fox

iTrader: (3)

Secconding this. If you can't find them in your area, billy at respeed stocks them too.

OneRotor

iTrader: (3)

just buy pre-made ones

dbragg

iTrader: (7)

For a stock ignition set up, stock NGK is the most logical way to go. For somone with a custom set up, its the persons decision.

I have a FC coil on my drivers side strut tower. I think I am using FB/FC coils. I am not sure, theyre too long, but I am not that worried abou it. I may address it in the future though, probably not unless a problem arises.