1st Generation Specific (1979-1985) 1979-1985 Discussion including performance modifications and technical support sections

blown engine?

Thread Tools
 
Search this Thread
 
Old Feb 4, 2004 | 10:22 PM
  #1  
Thread Starter
Junior Member
Tenured Member 05 Years
 
Joined: Jan 2004
Posts: 17
Likes: 0
From: tn
blown engine?

yea only had my seven for about a week. parked outsidework came to start it and let it warm up for a while befor going home came back out 20 min. later and there was coolant all over the groun and the radiator was smoking. i have driven the car alot since i got it and the temp stayed very low at about a quater checked all the hoses and they seem to be fine any suggestions on what it could be.? thanks
Reply
Old Feb 4, 2004 | 10:30 PM
  #2  
wwilliam54's Avatar
it WILL run
Tenured Member 10 Years
 
Joined: Dec 2002
Posts: 2,017
Likes: 1
From: Raleigh,MS
check the rad cap
Reply
Old Feb 4, 2004 | 10:33 PM
  #3  
bizarro's Avatar
Rotary Enthusiast
Tenured Member 05 Years
iTrader: (1)
 
Joined: Aug 2003
Posts: 1,171
Likes: 0
From: NJ
did you check the heater hose near the oil filler neck?
Reply
Old Feb 4, 2004 | 10:37 PM
  #4  
Thread Starter
Junior Member
Tenured Member 05 Years
 
Joined: Jan 2004
Posts: 17
Likes: 0
From: tn
no i will have to check that
Reply
Old Feb 4, 2004 | 10:39 PM
  #5  
bizarro's Avatar
Rotary Enthusiast
Tenured Member 05 Years
iTrader: (1)
 
Joined: Aug 2003
Posts: 1,171
Likes: 0
From: NJ
there are 2 heater hoses that come from the block into the firewall...the one near the oil filler neck is usually the culprit because if oil spills on it the rubber begins to break down...i hope you didn't drive it like that because at that point driving the car with no coolant can warp the housings
Reply
Old Feb 4, 2004 | 10:44 PM
  #6  
Thread Starter
Junior Member
Tenured Member 05 Years
 
Joined: Jan 2004
Posts: 17
Likes: 0
From: tn
i just checked everything as far as hoses and the radiator cap and they are all good. but when i started the car after i let it cool and refilled the coolant and let it run for a little while the temp gage goes to about 3/4 then all of a sudden drops to a quarter what is this about.?
Reply
Old Feb 4, 2004 | 11:26 PM
  #7  
FC Wanna-B's Avatar
Full Member
Tenured Member 05 Years
 
Joined: Jan 2004
Posts: 56
Likes: 0
From: Friendswood, Tx
maybe you need a new thermastat(sp?) to fix the issue with the temp acting screwy and there has to be a place that the coolant came out of if you can run the car let it run for a while and just watch the engine and underneath the car
Reply
Old Feb 4, 2004 | 11:30 PM
  #8  
bizarro's Avatar
Rotary Enthusiast
Tenured Member 05 Years
iTrader: (1)
 
Joined: Aug 2003
Posts: 1,171
Likes: 0
From: NJ
if its a 13b there are 2 more coolant lines under the dynamic chamber/throttle body...if its a 12a then i'm stumped...good luck
Reply
Old Feb 4, 2004 | 11:57 PM
  #9  
hornbm's Avatar
FD > FB > FC
Tenured Member: 20 Years
 
Joined: Oct 2002
Posts: 3,873
Likes: 3
From: Bothell, WA
I'm having a problem with this too, my cooling system cools TOO well. I never get above a quarter on the guage, and thats with the electric fan off.
Reply
Old Feb 5, 2004 | 04:20 PM
  #10  
Thread Starter
Junior Member
Tenured Member 05 Years
 
Joined: Jan 2004
Posts: 17
Likes: 0
From: tn
whent out and got new thermostat and radiator cap but when i whent to put the cap on the radiator there is all kind of hard white pieces. i dont know if these are the prob but i knew it cant be good?
Reply
Old Feb 5, 2004 | 04:48 PM
  #11  
BigJim's Avatar
trainwreck
Tenured Member 10 Years
 
Joined: Jun 2003
Posts: 1,725
Likes: 2
From: Lake, Michigan
On my se sometimes when i park on an incline coolant will just leak out. I have no clue why it does it, and ive checked hoses adn resevoirs and they all seem fine
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
The Shaolin
2nd Generation Specific (1986-1992)
9
Sep 14, 2015 07:50 PM
cdn
2nd Generation Specific (1986-1992)
14
Sep 10, 2015 06:23 AM
cdn
2nd Generation Non-Technical and pictures
0
Aug 11, 2015 08:59 PM




All times are GMT -5. The time now is 06:03 PM.