1st Generation Specific (1979-1985) 1979-1985 Discussion including performance modifications and technical support sections

Bad Vibrations

Thread Tools
 
Search this Thread
 
Old 05-29-06, 01:14 PM
  #1  
Rotary Slave

Thread Starter
iTrader: (3)
 
FCKing1995's Avatar
 
Join Date: Jul 2005
Location: Birmingham, Alabama
Posts: 1,599
Likes: 0
Received 1 Like on 1 Post
Bad Vibrations

no matter what rpm or speed im at, there is a fairly harsh vibration throughout the car. its felt more in the shifter, could this be from a broken tranny mount (or worn out) i hear they tend to break or weaken and cause sag, in return make vibration and shaking... any ideas, i saw mazdatrix had a good deal on replacment mounts, might try one of those
Old 05-29-06, 01:19 PM
  #2  
Too old to act my age

 
Rogue_Wulff's Avatar
 
Join Date: Feb 2005
Location: Tulsa, Ok.
Posts: 3,164
Likes: 0
Received 0 Likes on 0 Posts
Yes, a bad trans mount can cause a vibration. I would start by checking the driveshaft. A bad u-joint can also cause this.
Old 05-29-06, 01:59 PM
  #3  
TACOCAT

 
OnlyOnThurs's Avatar
 
Join Date: Aug 2004
Location: Milky Way
Posts: 3,040
Received 1 Like on 1 Post
5 bucks says its a bad u-joint on your driveshaft! And if this is the case you will need a WHOLE new drive shaft. 79-82 had replaceable u-joints while 83-85 did NOT have replaceable u-joints. Start there first!
Old 05-29-06, 02:06 PM
  #4  
kiwi from downunder..

iTrader: (4)
 
blwfly's Avatar
 
Join Date: Nov 2005
Location: springfield,oregon
Posts: 3,423
Received 5 Likes on 5 Posts
my 7 vibrated really bad at all speeds rpm etc
what it was is that my drive sharft had only 3bolts in by bout 4 threads "accident wating to happen"

fixed it up added another bolt and vibrations were gone altho i still had bad engine and tranny mounts so there was a lil vibration at idel
Old 05-30-06, 06:46 PM
  #5  
Rotary Slave

Thread Starter
iTrader: (3)
 
FCKing1995's Avatar
 
Join Date: Jul 2005
Location: Birmingham, Alabama
Posts: 1,599
Likes: 0
Received 1 Like on 1 Post
thanks for the tip, i guess when i go to rebuild the motor ill go ahead and go solid engine mount, new tranny mount, anything wrong with going aluminum driveshaft? kinda want lighter, dont guess it would hurt any worse than a light flywheel, which im also getting at rebuild time along with new clutch and streetport, drive it like that until i can get enough saved up for the full 13b swap and build
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
squirrels
1st Generation Specific (1979-1985)
9
03-22-22 02:23 AM
Logan Reinisch
General Rotary Tech Support
44
09-17-18 12:20 PM
Jmolina0163
1st Generation Specific (1979-1985)
10
10-03-15 10:04 AM
Jmpabon93
New Member RX-7 Technical
1
09-30-15 04:57 PM



Quick Reply: Bad Vibrations



All times are GMT -5. The time now is 05:35 PM.