Boston Mangler

Hey Guys

Anyone ever get any work done at this place??

http://www.rotaryracing.com/

I am thinking of having them do some custom work getting a Turbo II motor into a Sand Rail i am building and was wondering if anyone has used them for anything first hand? Good or bad???

They are only 1.5 hours from me

I have heard mixed things about them but they seemed very helpful and friendly on the phone

Anyone have any input about them?

Thanks A Lot

Tom

I basicaly just asked the same question. 10 years ago I bought a street ported 4 port 13B from them. It was a great motor. The only prob was their install on the centerforce clutch. It was not aligned right and I had to pull it back out and correct. Other than that, my 81 ran like a bat out of hell..
I have since sold the car (many years ago) and will get another. I asked readers to post their comments to see if they are still reputable or what their feedback is (10 years is a looong time!)

RacerX7fb

Nick has been around rotaries for a long time..set a land speed record on street tires!
MechTech in Escondido has made many rotary sand rails..talk to Jim

Tom

Newbie here too..Searched under vendors and found recent posts regarding them..

https://www.rx7club.com/forum/showth...hreadid=148632

I guess nothing has changed after 10 years..

RotorMotorDriver

iTrader: (1)

Theyre also the ones that prepare and sell the Weber setups to MazdaTrix if that means anything to anyone.

~T.J.