Any good experiences with stripped emissions?
Originally Posted by trochoid
If the choke doesn't stay out on it's own, check the temp sensor on the backside of the waterpump housing. That sends a signal to the ecu that in turn controls the magnet in the choke.
My choke works fine with the Mikuni, just like stock. It didn't until I replaced that temp sensor. Broke the wires on the old one, installed a new one and all is good now.
If you have stripped all of the vacuum parts of the choke off of the carb, all the choke will do is raise the idle for warm up.
If you have stripped all of the vacuum parts of the choke off of the carb, all the choke will do is raise the idle for warm up.
yeah, u were right trochoid, the harness was unplugged, but now that i plugged it in the car gets like when u have a bad fuel filter, if u give it gas it goes slower, so i plugged in all the other plugs behind the carburetor and its ok. does no rats nest make the internal part of the engine like oil and stuff dirty,does it affect the engine at all in a bad way, besides making the exhaust stink lol
nice car by the way trochoid
nice car by the way trochoid Thread
Thread Starter
Forum
Replies
Last Post
Machupicchu
1st Generation Specific (1979-1985)
8
Aug 17, 2015 08:27 PM



