Any advise?
#1
Punk Ass Bitch
Thread Starter
Join Date: Dec 2003
Location: Welland, Ontario
Posts: 99
Likes: 0
Received 0 Likes
on
0 Posts
Any advise?
Damned oil tube will not come off I tried pulling and wiggling it with a dumb wrench for an hour or two.
It's probably really old, so it there a different tool I could use instead of my Vise Grips to get this damned thing off?
Thanks.
It's probably really old, so it there a different tool I could use instead of my Vise Grips to get this damned thing off?
Thanks.
#2
Nikki-Modder Rex-Rodder
Join Date: Feb 2001
Location: Trying to convince some clown not to put a Holley 600 on his 12a.
Posts: 2,890
Likes: 0
Received 14 Likes
on
6 Posts
Rubber mallet is best; piece of pine (soft) 2x4 is next best.
Whack it softly side to side, up and down. It's not threaded or crimed. Just push fit.
If you're installing another one, just tap it in dead even on the top of it.
Whack it softly side to side, up and down. It's not threaded or crimed. Just push fit.
If you're installing another one, just tap it in dead even on the top of it.
#5
Punk Ass Bitch
Thread Starter
Join Date: Dec 2003
Location: Welland, Ontario
Posts: 99
Likes: 0
Received 0 Likes
on
0 Posts
Wow, that was the best 5 minutes i ever spent! Now, how about that rubber hose. I don't want to wreck it, what's the best way the take that off?
Thread
Thread Starter
Forum
Replies
Last Post
eplusz
General Rotary Tech Support
15
10-07-15 04:04 PM
Red-Dragon_Akuma
New Member RX-7 Technical
11
09-28-15 06:09 AM