another dumb "wheres it go?" question
Thread Starter
It's Back!
Joined: Mar 2001
Posts: 1,049
Likes: 1
From: Cincinnati
another dumb "wheres it go?" question
On the top rear of my engine, there is a small metal cylinder bolted down with about a 4 inch wire that ends in a male connector. My guess was that it is some kind of radio interference device or a ground, but I can't find the other end. Sooo where does it go? 
standard combustion
Joined: Dec 2001
Posts: 1,374
Likes: 0
From: Twin Cities Minnesota
Disconnect it and look at your oil pressure guage. Its wire connects to the wiring that is with all the emission solinoid wires.. IT connects to the female connector...kinda hiden in there.
This cylinder is a reference resistor for the signal for the oil pressure gauge. If I remember its like 1.86ohms or so, can't remember though.
This cylinder is a reference resistor for the signal for the oil pressure gauge. If I remember its like 1.86ohms or so, can't remember though.
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic S5 Turbo PNP Unit questions
_Tones_
Adaptronic Engine Mgmt - AUS
10
May 25, 2021 05:37 AM
HalifaxFD
Canadian Forum
126
May 9, 2016 07:06 PM