89-91 TII Trans Mount Picture Request
04-10-04, 11:40 PM
#27
Senior Member
Thread Starter
Join Date: May 2003
Location: Easton, PA
Posts: 252
Likes: 0
Received 0 Likes
on
0 Posts
ok, just to clear it up, if i get a s4 trans, it WILL fit without cutting right? I really would rather buy another trans then cut up my interrior... i put a lot of time into the interrior... the 3/4" bar trick should work right?
Last edited by CheddaKing; 04-10-04 at 11:59 PM.
04-11-04, 12:05 AM
#28
Originally posted by CheddaKing
ok, just to clear it up, if i get a s4 trans, it WILL fit without cutting right? I really would rather buy another trans then cut up my interrior... i put a lot of time into the interrior... the 3/4" bar trick should work right?
ok, just to clear it up, if i get a s4 trans, it WILL fit without cutting right? I really would rather buy another trans then cut up my interrior... i put a lot of time into the interrior... the 3/4" bar trick should work right?
04-11-04, 01:37 AM
#29
HEAVY METAL THUNDER
Join Date: Oct 2002
Location: Elsenborn, Belgian Eifel
Posts: 3,864
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by Directfreak
My guess is that you have an S5 N/A transmission.
My guess is that you have an S5 N/A transmission.
As far as I know, that doesn't look like a NA transmission. NA ones are more or less the same then those in our first gens (S2-3). Actually, I have a S4 one standing next to a S3 (I pulled both from complete cars so I'm sure they are correct) and can't tell the difference when they are next to eachother.
All transmissions would basicly bolt on, as rear housings are all the same bolt pattern (even those on RX-8's) but you'd need the matching flywheel, I guess.
I still only have a TII engine, no gearbox yet, so I can't help a lot with mounting etc. That's my next problem in the swap...
Thread
Thread Starter
Forum
Replies
Last Post
82streetracer
1st Generation Specific (1979-1985)
7
08-23-15 09:28 AM