84-85 NipponDensu A/C compressor question
#1
Full Member
Thread Starter
Join Date: Jun 2002
Location: CA
Posts: 245
Likes: 0
Received 0 Likes
on
0 Posts
84-85 NipponDensu A/C compressor question
I have an 85 with a Nippon Densu A/C compressor. I have a question about the lower mount for the A/C compressor. It loks to me like someone had modified it with the worng bolts before i had bought it. I have replaced the compressor, but the bolts look fishy to me.
If someone has one could you please check how the bottom mount bolt looks, please.
Is it 2 bolts for the front and back flanges?
Is it just one big bolt that goes both flanges, similar to the alternator or air pump?
I went to the Mazda dealer but their slides don't show the actual bolt and they cannot order the right parts for me.
I think the the bottom of my A/C is loose fromt he worng bolts because I get a vibration when running it. Thanks.
If someone has one could you please check how the bottom mount bolt looks, please.
Is it 2 bolts for the front and back flanges?
Is it just one big bolt that goes both flanges, similar to the alternator or air pump?
I went to the Mazda dealer but their slides don't show the actual bolt and they cannot order the right parts for me.
I think the the bottom of my A/C is loose fromt he worng bolts because I get a vibration when running it. Thanks.
#4
Full Member
Thread Starter
Join Date: Jun 2002
Location: CA
Posts: 245
Likes: 0
Received 0 Likes
on
0 Posts
Hehe. If it's 2 in the front and 2 in the back I think it's a sanyo-denki. Sanyo's are located very low in the engine bay, with 2 drive belts and are the dealer installed units (least what I was told). Nippon Densu are factory and ride very high up (above the power steering). Thanks for checking though.
Thread
Thread Starter
Forum
Replies
Last Post