83 gsl diff in a 82 gs axle housing
Thread Starter
Full Member
Joined: Sep 2005
Posts: 91
Likes: 1
From: minnesota
83 gsl diff in a 82 gs axle housing
From my understanding the diff should bolt into the housing but the axle flange won't match the driveshaft.
I am going to remove the axle flange from the old diff to install on the new diff.
The manual mentions preload on the diff. But it also mentions that the nut needs to be torqued to 130ft lb.
Am I safe by swapping flanges and torquing to 130ft lb or do I need to check preload and what is the proper procedure for checking preload?
Thanks!
I am going to remove the axle flange from the old diff to install on the new diff.
The manual mentions preload on the diff. But it also mentions that the nut needs to be torqued to 130ft lb.
Am I safe by swapping flanges and torquing to 130ft lb or do I need to check preload and what is the proper procedure for checking preload?
Thanks!
Thread Starter
Full Member
Joined: Sep 2005
Posts: 91
Likes: 1
From: minnesota
https://www.rx7club.com/1st-generati...torial-711712/
I apologize, I believe this is the answer I have been looking for
It is not as easy as impacting one to the other
I apologize, I believe this is the answer I have been looking for
It is not as easy as impacting one to the other
Thread
Thread Starter
Forum
Replies
Last Post
realryan
New Member RX-7 Technical
15
Nov 10, 2015 03:09 PM
ricardo.benin
3rd Generation Specific (1993-2002)
13
Nov 5, 2015 07:52 PM