i was wonderin, would 48ida webers from a VW fit on a rotary? is it a different design? or hell are they exactly the same? if they are the same ill steal some from my bro-in-laws bug. my thoughts was that they where different

 

the carb is the same , but most of the internals need to be changed for it to work properly on a rotary. the bug uses 2 so the venturies, fuel jets, e-tubes, accelerator pump jet will be too small for the rotary since your only using one.

 

how would i go around to making it rotary worthy? is there a kit to buy? or would i be better off just buying one setup for a rotary already?

 

It's not a kit as such. You simply need to buy the correct parts so it will meet the tuning requirements of the rotary. Like 680 said you need new venturis, fuel and air jets, emulsion tubes, accelerator pump jet as well as the idle jets, idle jet holders and you can probably thrown in a bigger needle and seat as well. Exactly what you use will depend on your engine setup.

 

well said!
i have the parts if you need them!
like REVHED said, there is no kit, alll weber parts are sold individually