40mm solex carb good enough for 12a?
Thread Starter
Rotary Freak
Joined: Sep 2004
Posts: 1,901
Likes: 0
From: Kitchener, Ont. Canada
40mm solex carb good enough for 12a?
as far as i know....solex=mikuni
is a 40mm going to cut it for an otherwise stock 12a???
what if i decide to port? will it then not be enough???
any one with experience with a 40mm solex/mikuni?
nick
is a 40mm going to cut it for an otherwise stock 12a???
what if i decide to port? will it then not be enough???
any one with experience with a 40mm solex/mikuni?
nick
Rotary Freak
Joined: Mar 2003
Posts: 1,711
Likes: 0
From: Calgary, Alberta, Canada
Check out www.rotaryaviation.com and email Tracy Crook (the site owner) with any questions regarding the Mikunis carbs (three of them) that he re-jetted to feed fuel to the original stock 1988 13B that he used to have in his RV-4 sport plane. (He's now running a Fuel-injected Renesis engine in this plane).
He can likely provide you with info on the correct jets and manifold set-up that would give you the best volumetric efficiency.
He can likely provide you with info on the correct jets and manifold set-up that would give you the best volumetric efficiency.
Thread
Thread Starter
Forum
Replies
Last Post
alphawolff
1st Generation Specific (1979-1985)
17
Nov 17, 2015 05:57 PM
12a, 40mm, c212, carb, carbs, carburetor, carburetors, club, generation, good, mikuni, rx7, single, solex, solox
