2nd Gen header on 1st Gen 13B engine. What angle issues for pipe?
#1
7-less
Thread Starter
Join Date: Dec 2005
Location: No. Virginia, USA
Posts: 2,053
Likes: 0
Received 0 Likes
on
0 Posts
2nd Gen header on 1st Gen 13B engine. What angle issues for pipe?
So, I have a 2nd Gen NA header from Racing Beat and before I go to install it and have someone weld up some "filler" pipe for me (can't afford a pro shop to do it), I'm wondering of the angle issues I may encounter.
IIRC, I was told that the end of the 2nd Gen header points down a bit more than the header for a 1st Gen 13B. I also have a flange to weld onto the pipe to connect to the header.
IIRC, I was told that the end of the 2nd Gen header points down a bit more than the header for a 1st Gen 13B. I also have a flange to weld onto the pipe to connect to the header.
#5
7-less
Thread Starter
Join Date: Dec 2005
Location: No. Virginia, USA
Posts: 2,053
Likes: 0
Received 0 Likes
on
0 Posts
I'm sure it can be done, I'm just wondering of the angle that I may face. How much different is the FC header compared to the FB header? Doesn't it aim a bit lower?
Thread
Thread Starter
Forum
Replies
Last Post
KAL797
Test Area 51
0
08-11-15 03:47 PM