13B into Rx-3 - no start
13B into Rx-3 - no start
Hi everyone! I am working on a Rx-3 w/ Gsl-SE motor for someone. This car ran fine and all of a sudden it will not start. Has spark -leading/trailing, fuel pump comes on w/ flow to rails, 12v @ injectors, fusible links have continuity, main relays are good, trailing signal wire to ecu ok, engine grounds are good, plugs are all dry, just can't seem to get the injectors to pulsate, if the a.f.m and trailing igniter crapped out will I still get spark and fuel?-read about this and there were many mixed opinions.
Thanks everyone , hopefully this not a repeat, I have searched thru threads and archives spending many hours and still cant find the problem....
Thanks again!!!
Thanks everyone , hopefully this not a repeat, I have searched thru threads and archives spending many hours and still cant find the problem....
Thanks again!!!
Last edited by tUrDbO_wOLFeD-7; Jul 6, 2007 at 10:08 PM. Reason: technical
We are having the same problem with my sons gle we did the swap . we have pulled the plugs and no fuel dry dry dry dry. where does the negative charge to the injectors come from and how can we find it . he swap was not bad except for the fact the car will not start. the only thing is the injectors will not pulse. we replaced the orginal ones and no luck the fuel presure is around 50 psi the rails have fuel the ecu seams good. are at a loss. thanks
Thread
Thread Starter
Forum
Replies
Last Post
1993fd3sracer1
1st Generation Specific (1979-1985)
20
Sep 7, 2015 11:50 AM
Machupicchu
1st Generation Specific (1979-1985)
8
Aug 17, 2015 08:27 PM
KAL797
Test Area 51
0
Aug 11, 2015 03:47 PM




