GenOneProject

i found a good 13b tt motor and i was wondering if it can be swapped into my 83 has anyone done this and knows if it is possable? is it relatively easy any clearance problems? any advice would be appreciated

trochoid

iTrader: (6)

If you can read, and I assume you can since you posted, then it can be done.
.
.
.

GenOneProject

so do i need to do anything special with the wiring?

trochoid

iTrader: (6)

Grab the entire wiring harness or go with a standalone ecu. There's a write up on TII wiring changes, not sure about the REW TT. This isn't a simple swap, both the wiring and fuel systems need redone/modded. Start reading.

GenOneProject

what about motor mounts? it comes as complete swap it is posted in the vender section do you think its a good deal at 1499?

PercentSevenC

Use a pre-'86 front cover for the motor mounts.

As for whether it's a good deal, it depends entirely on the condition of the engine and what's included.

ourxseven

iTrader: (1)

dont take this personally, but you are not getting the message . You need to read A LOT first because you are going to have about 8000 questions for this project and about 7,800 of them can be answered by using the search function and reading .

search , read , search , read , ask , search read .... etc. etc.