12at project starts back up!! few q's
#1
12at project starts back up!! few q's
So i have my rx7 all stripped down, just about to get it painted (black). I am about to trade for a microtech computer lt-8. I just want to make sure i get everything right. I am not sure how to setup a standalone system, I have an engine harness for a 86 non turbo rx7 and didnt know if that would help considering this guy says he hooked his up with a gslse car, i have half the harness on the engine and transmission so i could prob. I just want to know the cleanest and most professional way to hookup my microtech. Do i need an air flow meter with a microtech?
#4
Banned. I got OWNED!!!
with a microtech a flying lead harness is the way to go, each wire is labeled to ease installation and the directions are easy to follow.. you wont need a afm , since the microtech runs off map..
Thread
Thread Starter
Forum
Replies
Last Post
smikels
2nd Generation Specific (1986-1992)
3
08-18-15 01:26 PM