12a turbo parts
12-30-04, 08:32 PM
#3
Yeah, shutup kid.
I think one of the best sized turbos for the 12a is a TII turbo with the hybrd 60-1 compressor. It'll make enough power to run 11's and spools real fast. You can get a TII turbo, manifold, and wastegate used for around $300 and the new compressor mod is around $500-600. Or you could go with a t04b for $300 . It'll probably end up costing about the same. Since with the t04b you'll need a good manifold and wastegate which will probably cost about $500. You can use just about any intercooler you want. Just get the dimensions of it and make sure you've got the room to fit it up front. Just make sure the inlet size on the IC is the same as the turbo outlet. You can get most of the parts you need for a 12aT off of the forum or on ebay. There's no kit you can buy(unless you get lucky and find one of those weird old setups), you just have to do your research and piece together your own setup.
01-01-05, 08:32 PM
#4
Smoov-e "Dick Like Mine"
Thread Starter
iTrader: (2)
Join Date: Sep 2004
Location: Nor Cal assassin
Posts: 542
Likes: 0
Received 0 Likes
on
0 Posts
thax but i have a 12a from a 1983 rx7. im trying to buy a 12a turbo with tranny but has no harnesses. can i use the same one or i have to buy one just for the 12a turbo?
01-02-05, 12:38 AM
#5
If you want a stock ECU setup, then you need the 12A Turbo Harness. I heard that any GSL-SE ECU will work. The 12A Turbo harness plugs into the GSL-SE ECU, then you just need 4 wires more plugged into the ECU from your FB harness and it should work.
Thats what I heard at least.
Or you can buy an Engine Management System. Might have to sell your genetals on the black market though.
Thats what I heard at least.
Or you can buy an Engine Management System. Might have to sell your genetals on the black market though.
Thread
Thread Starter
Forum
Replies
Last Post
KAL797
Test Area 51
0
08-11-15 03:47 PM
