12a rotary housing question
#1
Junior Member
Thread Starter
Join Date: Aug 2006
Location: washington
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
12a rotary housing question
hey guys
I just tore apart the 12a out of a parts car that i got. My question is. how apparent will it be if a rotor housing is bad? i cant see or feel and grooves or nicks in the crome. can they warp??
thank you
Nic
I just tore apart the 12a out of a parts car that i got. My question is. how apparent will it be if a rotor housing is bad? i cant see or feel and grooves or nicks in the crome. can they warp??
thank you
Nic
#4
Blood, Sweat and Rotors
iTrader: (1)
You have to measure the width of the rotor housing. When it gets hot, it'll warp and compress. Which makes it narrower. You compare the width of the top of the housing where it's coolest, to the spark plug area where it's hottest. It can't differ too much. And there's a minimum width spec too.
Plus the usual corrosion and spark plug hole check.
Plus the usual corrosion and spark plug hole check.
#6
Senior Member
iTrader: (1)
Join Date: Aug 2010
Location: Southern Minnesota and Southern California
Posts: 340
Likes: 0
Received 0 Likes
on
0 Posts
Here SgtFox's link for the downloadable FSM DivinDriver mentioned;
http://foxed.ca/foxed/index.php?page=rx7manual#firstgen
http://foxed.ca/foxed/index.php?page=rx7manual#firstgen
Thread
Thread Starter
Forum
Replies
Last Post
cdn
2nd Generation Specific (1986-1992)
14
09-10-15 06:23 AM
cdn
2nd Generation Non-Technical and pictures
0
08-11-15 08:59 PM