Well I stripped my engine bay to clean it up for the engine I'm about to put in, and I forgot how the wiring harness goes. I don't want to put the engine in and reach for a wire that's 1" too far away, so does anyone have pictures of their engine bay empty with just the harness? Thanks.

 

Year of car(series 1 2 and 3 cars have different wiring)? options that effect under hood wiring (cruise control, A/C, power steering, 13B EFI or 12A, etc.)

I got my old Series 2 engine bay and my new series 3 engine bay:

Series 2 12A GSL:


Sereis 3 12A GSL:

 

It was a s3, I think I got it mostly figured out. Lets hope when I pop the engine in I'm not short on anything!

 

You can have a look at my build thread. Photos aren't as good as Chris', but at least it's a Series 3. I also went through a lot of debugging of stock hardware, so it may be helpful.

https://www.rx7club.com/1st-generation-specific-1979-1985-18/back-fb-looking-crash-course-all-things-gsl-se-713658/