openshot

hello I am having a problem removing my bottom dash from the rx7. Because I am swaping carpet. I looked every where on hear and found nothing. The problem I am having is geting the screw behind the plastic part behind the steering wheel. How can I get the the screw? here is a pic of where it is.

sa7

iTrader: (13)

Take the plastic pieces off the steering column first, and then the screw should be easily accessible. When I took my interior apart, thats what I did and didn`t have any problems.

openshot

how do you take the plastic piece off the steering column. are they one piece or 2?

sa7

iTrader: (13)

It comes off in two pieces. There should be a piece on the left and on the right of the steering column held together with three screws (if I remember correctly).

openshot

they are joined at the top.

RX-7 Chris

iTrader: (19)

they are 2 pieces. 2 screws attach them together and 2 or 3 screws attach them to the column.

Once they are off you will be able to get to the last screw in the dash.

openshot

they are all off and i still cant get to it.

RX-7 Chris

iTrader: (19)

Maybe someone glued it together at some point?

openshot

it kind of looks like its been glued. do you have a pic of that part off and on?

WAS:12A

iTrader: (4)

Nothing is glued together from the factory.

I got down to this point and back together using only a standard philips head screwdriver and a 10 + 12mm socket.

Just have a look around and you will figure it out.

You may have to remove the center console section as well to get to the part you want as all the sections of the dash sort of interlock together...

Keep exploring and take it slow so you don't break anything.

Cam...

openshot

thanks. well i got it off. i will have to glue it back because the tabs broke. but now i am having troble geting the carpet out.

trochoid

iTrader: (6)

Inside the lower center dash is a U shapped bracket. That bracket bolts to the tranny tunnel, the console bolts to that. Remove the bolts, pop out the bracket, will need to bend the console steel a tad to clear the alighnment pins, then the carpet can be slid out from under.

openshot

thanks. i got the carpet out and the new one in. i am hoping to have it all in tomarrow like seats and everything then i will have a fully black int pics will be when its done.