what is the length and width of the holes in a divided T4 flange?
Thread Starter
Rebreaking things
Joined: Jun 2001
Posts: 2,586
Likes: 0
From: 1 foot in Boston 1 in NJ
what is the length and width of the holes in a divided T4 flange?
I am trying to determine the size of the two holes rather than the bolt pattern. I already searched, which was a pita because 't4' is only two characters.
-Chris C
-Chris C
Freedoms worth a buck o'5
Joined: May 2001
Posts: 2,544
Likes: 1
From: Calgary Alberta Canada
Going from an old rotomaster print..
The bolt hole pattern is 2.75x3.25
the bolt holes are 3 @ .406" diam
1(upper left) @.440" diam
The gas passage holes themselves are 1.98"x1.36"
the divider wall in between them is .22"
The overall flange size (outside) is 3.75"x4.25"
Max
The bolt hole pattern is 2.75x3.25
the bolt holes are 3 @ .406" diam
1(upper left) @.440" diam
The gas passage holes themselves are 1.98"x1.36"
the divider wall in between them is .22"
The overall flange size (outside) is 3.75"x4.25"
Max
Thread Starter
Rebreaking things
Joined: Jun 2001
Posts: 2,586
Likes: 0
From: 1 foot in Boston 1 in NJ
Originally posted by Maxthe7man
The gas passage holes themselves are 1.98"x1.36"
the divider wall in between them is .22"
The gas passage holes themselves are 1.98"x1.36"
the divider wall in between them is .22"
-Chris
Thread
Thread Starter
Forum
Replies
Last Post
eplusz
General Rotary Tech Support
15
Oct 7, 2015 04:04 PM
